Inspection Procedure

INSPECT FUSE (D-IG, MPX-82)
1. Check that continuity exists of D-IG fuse.
2. Check that continuity exists of MPX-B2 fuse.
1. NG: REPLACE FUSE
2. OK: GO TO NEXT STEP
INSPECT COMBINATION METER ASSY (POWER SOURCE CIRCUIT)
1. Check voltage.
  1. Disconnect the "C8" connector from combination meter.
  2. Measure voltage between terminal B of combination meter connector and body ground.
    Voltage: 10-14 V
  3. Turn ignition switch ON.
  4. Measure voltage between terminals IG+, B of combination meter connector and body ground.
    Voltage: 10-14 V
  Fig 1: Measuring Voltage Between Terminals IG+, B Of Combination Meter Connector And Body Ground
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. NG: REPAIR OR REPLACE HARNESS OR CONNECTOR
2. OK: GO TO NEXT STEP
INSPECT COMBINATION METER ASSY (GROUND CIRCUIT)
1. Check continuity.
  1. Disconnect the "C8" connector from combination meter.
  2. Check continuity between terminal ES of combination meter connector and body ground.
  OK: Continuity exists
  
  Fig 2: Checking Continuity Between Terminal ES Of Combination Meter Connector And Body Ground
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. NG: REPAIR OR REPLACE HARNESS OR CONNECTOR
2. OK: CHECK AND REPLACE COMBINATION METER ASSY