Inspection Procedure

WARNING: This page is about a different car, the 2004 Lexus SC 430. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT INSTRUMENT CLUSTER FINISH PANEL SUB-ASSY CENTER (TILT)
1. Remove the instrument cluster finish panel sub-assy center with connector still connected.
2. Check voltage.
  1. Turn ignition switch ON.
  2. Measure voltage between terminal TILT of instrument cluster finish panel sub-assy center and body ground.
  Voltage:
  
  Fig 1: Tilt Switch Voltage Specification Table
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Fig 2: Identifying Connector Terminal TILT Of Instrument Cluster Finish Panel Sub-Assy Center
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. NG: CHECK AND REPLACE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSY CENTER
2. OK: REPAIR OR REPLACE HARNESS OR CONNECTOR