Steering System - General Information -- Defender/L663
- Steering System - General Information
- Description And Operation
- Diagnosis And Testing
- Steering System (G2400944)
- Principles Of Operation
- Inspection And Verification
- Symptom Chart
- Electric Power Steering Gear Inspection - With Heavy/NOTCHY Steering Gear
- Steering And Wheel Alignment
- Pinpoint Test - Mechanical
- DTC Index - PSCM
- DTC B1304-04: Electronic Power Assisted Steering System - System internal failures
- DTC B1304-16: Electronic Power Assisted Steering System - Circuit voltage below threshold
- DTC B1304-17: Electronic Power Assisted Steering System - Circuit voltage above threshold
- DTC B1304-98: Electronic Power Assisted Steering System - Component or system over temperature
- DTC C102D-07: High Friction Inside Power Steering - Mechanical failures
- DTC C1B00-62: Steering Angle Sensor - Signal compare failure
- DTC C200B-01: Steering Shaft Torque Sensor 1 - General electrical failure
- DTC C200B-31: Steering Shaft Torque Sensor 1 - No signal
- DTC U0046-81: Vehicle Communication Bus C - Invalid
- DTC U0046-82: Vehicle Communication Bus C - Alive/sequence counter incorrect/not updated
- DTC U0046-87: Vehicle Communication Bus C - Missing message
- DTC U0080-81: Vehicle Communication Bus F - Invalid serial data received
- DTC U0080-82: Vehicle Communication Bus F - Alive/sequence counter incorrect/not updated
- DTC U0080-87: Vehicle Communication Bus F - Missing message
- DTC U1A4C-53: Build/End of Line mode Active - Deactivated
- DTC U2100-56: Initial Configuration Not Complete - Invalid/incomplete configuration
- DTC U2300-55: Central Configuration - Not configured
- DTC U3000-47: Control Module - Watchdog/safety μ failure
- DTC U3001-00: Control Module Improper Shutdown - No sub type information
- Pinpoint Test - Electrical
- Notes
- Pinpoint Test B: Check The PSCM Power And Ground Circuit(S)
- Pinpoint Test C: Check The Power Steering Torque Sensor Power And Ground Circuit(S)
- Pinpoint Test D: Check The (Chassis) Signal/Circuit(S) To The PSCM
- Pinpoint Test E: Check The FLEXRAY Signal/Circuit(S) To The PSCM
- Pinpoint Test F: Check The FLEXRAY (Chassis) Signal/Circuit(S) To The PSCM
- Data Identifier (Did) D020 Table
- DTC Index
- Steering System (G2400944)