Rear Wheel Speed Sensor: Removal
NOTE:
Removal steps in this procedure may contain installation details.
- Disconnect the battery ground cable. Refer to Specifications .
- Raise and support the vehicle.
- Refer to Rear Fender Splash Shield .
- See figure
- See figure
- See figure
- Torque: 8 Nm
WARNING:
Make sure to support the vehicle with axle stands.
CAUTION:
Before disconnecting or removing the components, ensure the area around the joint faces and connections are clean and dry. Plug open connections to prevent contamination.
NOTE:
Left hand shown, right hand similar.
CAUTION:
Make sure that the component is clean, free of foreign material and lubricant.
CAUTION:
Make sure that the mating faces are clean and free of foreign material.
CAUTION:
Make sure that the sensor tip is clean and free of foreign material.
NOTE:
Left hand shown, right hand similar.