Throttle Position Sensor: Service and Repair

Service repair no - 19.22.49

Remove







1. Disconnect TP sensor multiplug.
2. Remove 2 bolts securing TP sensor to throttle body.
3. Remove TP sensor and discard 'O' ring.

Refit
4. Clean TP sensor and throttle body mating faces.
5. Using a new 'O' ring, position TP sensor, fit bolts and tighten to 2.2 Nm (1.5 labor. ft).
6. Connect TP sensor multiplug.
7. If fitting new TP sensor, connect Testbook to check for correct operation.