October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Circuit Inspection

G15726923

Courtesy of KIA MOTORS AMERICA, INC.

G15726924

Courtesy of KIA MOTORS AMERICA, INC.

Inspection Condition	(+) Probe		(-) Probe		Specification
Inspection Condition	Connector	Terminal	Connector	Terminal	Specification
Disconnect the electrical connector(s) from the concerned component. Ignition "ON".	HO2S (Bank2, Sensor1) connector	1 (nernst voltage)	Chassis ground	-	Approx. 0V
	HO2S (Bank2, Sensor1) connector	3 (virtual ground)	Chassis ground	-	Approx. 0V
	HO2S (Bank2, Sensor1) connector	4 (trim resister)	Chassis ground	-	Approx. 0V
	HO2S (Bank2, Sensor1) connector	6 (pumping current)	Chassis ground	-	Approx. 0V
Ignition "OFF". Disconnect battery (-) cable. Disconnect the electrical connector(s) from the concerned component and ECM.	HO2S (Bank2, Sensor1) connector	1 (nernst voltage)	Chassis ground	-	∞ (infinity)Ω
	HO2S (Bank2, Sensor1) connector	3 (virtual ground)	Chassis ground	-	∞ (infinity)Ω
	HO2S (Bank2, Sensor1) connector	4 (trim resister)	Chassis ground	-	∞ (infinity)Ω
	HO2S (Bank2, Sensor1) connector	6 (pumping current)	Chassis ground	-	∞ (infinity)Ω
	HO2S (Bank2, Sensor1) connector	1 (nernst voltage)	ECM connector	80 (nernst voltage)	Approx. below 1Ω
	HO2S (Bank2, Sensor1) connector	3 (virtual ground)	ECM connector	102 (virtual ground)	Approx. below 1Ω
	HO2S (Bank2, Sensor1) connector	4 (trim resister)	ECM connector	101 (trim resister)	Approx. below 1Ω
	HO2S (Bank2, Sensor1) connector	6 (pumping current)	ECM connector	79 (pumping current)	Approx. below 1Ω

Good

Go to "COMPONENT INSPECTION " procedure.

No Good

Repair or replace as necessary and then, Go to "VERIFICATION OF REPAIR " procedure.