Inspection Procedure
- Refer to
"EVAPORATIVE EMISSION CONTROL SYSTEM
" and visually and/or physically inspect following conditions;
- Check EVAP canister for fuel saturation. If the EVAP canister is full of fuel, inspect EVAP and fuel system.
- Remove the manifold side vacuum hose from the EVAP canister purge valve.
- Using a hand vacuum pump, apply specified vacuum to the manifold side of the valve.
- Has any problems been found?
Good
- Go to "FUEL SYSTEM INSPECTION " procedure.
No Good
- Repair as necessary and than Go to "VERIFICATION OF REPAIR " procedure.