LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2024 >> EV6 Light >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System Control Module (SRSCM) And Sensors >> SRS Control Module (SRSCM) >> Removal And Installation >> Installation
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Removal And Installation: Installation

WARNING:
  • When working on the high voltage system, the work should be performed by technicians who have completed the relevant training. A lack of understanding of the high voltage system can lead to serious accidents due to electric shock or short circuit.
  • When working on the high voltage system or related components, be sure to observe and be aware of the HIGH VOLTAGE SYSTEM GENERAL SAFETY INFORMATION AND CAUTION . If not, it may cause serious accidents due to electric shock or short circuit.
  • When working on high voltage system, make sure to check the Personal Protective Equipment (PPE) and HIGH VOLTAGE SHUT-OFF PROCEDURES .
  1. Install in reverse order of removal.
    WARNING: In the case of the SRSCM with the rollover detection function applied, the airbag may be deployed due to the movement generated during the installation, so do not install the SRSCM while the battery is connected or less than 3 minutes and 30 seconds after the battery is disconnected.
  2. After installing the SRSCM, make sure that the airbag system operates normally.
NOTE: When the IG is on, the airbag warning lamp should turns off after turning on for 3 - 6 seconds.
scientia non olet · About LEMON Manuals