LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2019 >> Sedona L >> Repair and Diagnosis >> External Pages >> Different car >> Section 41 (Supplemental Restraint System Control Module (SRSCM) And Sensors) >> Passive Occupant Detection System (PODS-F) >> Repair Procedures >> Installation >> Pods-F ODU
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Pods-F ODU

WARNING: This page is about a different car, the 2020 Kia Sedona. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the PODS-F ODU on the Front seat track assembly.
  2. Connect the PODS-F ODU connector.
  3. Install the front passenger seat assembly.

    (Refer to Body - "FRONT SEAT ")

  4. Reconnect the battery negative cable.
  5. After installing the PODS-F, confirm proper system operation:
    • Turn the ignition switch ON the SRS indicator should be turned on for about six seconds and then go off.
    • Telltale lamp will turn on for 4 seconds and then off for 3 seconds. After the 7 seconds, it shall remain off if the PODS-F does not require suppression and the passenger airbag is enabled.
NOTE: Be sure to perform PODS-F reset with KDS after replacing PODS-F ODU in the seat track.
scientia non olet · About LEMON Manuals