Repair Procedures: Removal

NOTE: If replacement of the bracket or extension wire of BSD unit is required, it is recommended to surely replace the defective part only with a new one, not the whole BSD unit.

Disconnect the negative (-) battery terminal.
Remove the rear bumper.
(Refer to "REAR BUMPER COVER ")
Disconnect the BSD connector (A) from the BSD unit.

Fig 1: Disconnecting BSD Connector From BSD Unit
Courtesy of KIA MOTORS AMERICA, INC.
Remove the BSD assembly (A) after loosening the mounting nuts.
Tightening torque : 3.9 - 5.9 N.m (0.4 - 0.6 kgf.m, 2.9 - 4.3 lb.ft)

NOTE: Be careful not to damage the bracket when removing the BSD unit.

Fig 2: Removing BSD Assembly Mounting Nuts

Courtesy of KIA MOTORS AMERICA, INC.

Information

In the following cases, replace the extension wire or bracket.

If the bracket is physically deformed or damaged.
- Remove the bracket (A) from the BSD unit by loosening the screws.
Fig 3: Removing Bracket From BSD
Courtesy of KIA MOTORS AMERICA, INC.
If the connector or wire is damaged.
- Remove the extension wire (A) after separating the mounting clip.
Fig 4: Removing Extension Wire Mounting Clip
Courtesy of KIA MOTORS AMERICA, INC.