September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Power Circuit Inspection

Check voltage
1. IG "OFF". Disconnect ETC Motor & TPS connector.
2. IG "ON".
3. Measure voltage between TPS power terminal of ETC Motor & TPS harness connector and chassis ground.
  Specification: Approx. 5V
4. Is the measured voltage within specification?
  YES
  - Go to "SIGNAL CIRCUIT INSPECTION " procedure.
  NO
  - Repair open or short to ground in power harness. Go to "VERIFICATION OF VEHICLE REPAIR " procedure.