Repair Procedures: Installation

Remove the ignition key from the vehicle.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
Install the SRSCM with the SRSCM mounting bolts.
Tightening torque:

8.0 ~ 10.0 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)

Fig 1: Locating SRSCM Mounting Bolts
Courtesy of KIA MOTORS AMERICA, INC.

NOTE: Use new mounting bolts when replacing the SRSCM after a collision.
Connect the SRSCM harness connector.
Install the rear vent duct and floor console. (Refer to the CONSOLE )
Reconnect the battery negative cable.
After installing the SRSCM, confirm proper system operation:
1. Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.