LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2013 >> Optima SX >> Repair and Diagnosis >> External Pages >> Different car >> Section 66 (4WD Control System Diagnosis) >> DTC P1836: Bleed Pressure Line Test Error >> Scantool Diagnostics >> Monitor Scantool Data
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Monitor Scantool Data

WARNING: This page is about a different car, the 2013 Kia Sportage and 2012 Kia Sportage. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect scantool to Data Link Connector (DLC)
  2. IG key "ON", Engine "ON".
  3. Warm up the engine to normal operating temperature.
  4. Monitor diagnostic trouble code and present of trouble code.

    Using a scantool, Check if the same DTC re-sets after clearing DTC.

  5. Are any DTCs present?

    YES 

    • Substitute with a known-good "Coupling" and check for proper operation. If the problem is corrected, replace "Coupling" and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

scientia non olet · About LEMON Manuals