Ground Circuit Inspection

Specification :  Approx. 0Ω

For 2012

Fig 1: Measuring Resistance Between Ground Terminal Of HO2S (B1S2) Harness Connector & Chassis Ground

Courtesy of KIA MOTORS AMERICA, INC.

For 2013 refer to ETM 

YES 

• Go to "SIGNAL CIRCUIT INSPECTION " procedure.

NO 

• Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
  NOTE:

  HO2S must have a clean air reference to function properly. The air is obtained by way of the sensor wire(s). Do not attempt to repair the wire(s), connector, or the terminals.