LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2012 >> Optima LX, Automatic Trans >> Repair and Diagnosis >> Brakes >> Traction Control >> Electronic Stability Control System Diagnosis - Except HEV >> DTC C1611: CAN Time-Out ECM >> General Information >> Monitor GDS Data
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Monitor GDS Data

  1. Connect GDS and select "DTC Analysis" mode.
  2. Confirm that "DTC Readiness Flag" indicates "COMPLETED". If not, drive the vehicle within conditions noted in the freeze frame data or enable conditions
  3. Read "DTC Status"parameter in DTC menu of the GDS
    4. Fig 1: Scantoll Display - DTC Information
    G00535598Courtesy of KIA MOTORS AMERICA, INC.
  4. Is parameter displayed "History(Not Present) fault" ?

    YES 

    Fault is intermittent caused by poor connection and/or HECU's connector or was repaired and HECU memory was not cleared.

    Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.

    Repair or replace as necessary and then go to VERIFICATION OF VEHICLE REPAIR  procedure.

    NO 

    Go to next step

scientia non olet · About LEMON Manuals