Repair procedures: Installation
WARNING: This page is about a different car, the 2011 Hyundai Tucson. However, it is still accessible from the selected car via links, so may be relevant.
- Install the PODS equipped seat cushion assembly. (Refer to the SEAT CUSHION COVER REPLACEMENT .)
- Install the front passenger seat assembly. (Refer to the SEAT ASSEMBLY REPLACEMENT .)
- Reconnect the battery negative cable.
- After installing the PODS, confirm proper system operation:
- Turn the ignition switch ON; the SRS indicator should be turned on for about six seconds and then go off.
Telltale lamp will turn on for 4 seconds and be turned off for 3 seconds. After the 7 seconds, it shall remain off if the PODS does not require suppression and the passenger airbag is enabled.
NOTE: Be sure to perform PODS reset with scantool after replacing PODS equipped seat cushion.
- Turn the ignition switch ON; the SRS indicator should be turned on for about six seconds and then go off.