LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2010 >> Rio Base >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Control System Diagnosis (1 Of 2) >> DTC P0130: O2 Sensor Circuit (Sensor1) >> Inspection/Repair >> W/Harness Inspection >> Signal Circuit Inspection
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Signal Circuit Inspection

  1. IG "OFF".
  2. Disconnect HO2S (B1/S1) connector.
  3. IG "ON" & ENG "OFF".
  4. Measure voltage between terminal 2 of HO2S (B1/S1) and chassis ground.
    1. Specification : Approx. 0.45V
      Fig 1: Measuring Voltage Between Terminal 2 Of HO2S (B1/S1) And Chassis Ground
      G06830523Courtesy of KIA MOTORS AMERICA, INC.
  5. Is the measured voltage within specification?

    YES

    1. Go to "GROUND CIRCUIT INSPECTION " procedure.

    NO

    1. Repair or replace as necessary and then, go to "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About LEMON Manuals