Inspection Procedure

Refer to PREPARATION OF INSPECTION .

1. Disconnect the BS connector.
2. Measure resistance between the terminal 2 of BS harness connector and chassis ground.
3. Measure resistance between the terminal 2 and 3 of BS harness connector.

   specification (Resistance) : Infinite

   Fig 1: Measuring Resistance Between BS Sensor Harness Connector Terminals / Chassis Ground

   Courtesy of KIA MOTORS AMERICA, INC.
4. Is the measured resistance within specification?

5. YES 

   • Go to next step.

   NO 

   • Repair the short or short to ground circuit on wiring harness between the BS and the SRSCM.

1. Measure current between the terminal 2 of BS and 69 (68) of SRSCM harness connector.

   specification (current) : 12 ~ 17 mA (Buckled status) , 4 ~ 7 mA (Unbuckled status)

2. Is the measured current within specification?

   YES 

   • Go to next step.

   NO 

   • Replace the BS.

Refer to CLEAR THE DTC AND CHECK THE VEHICLE AGAIN .