Component Inspection: Notes

NOTE: It is necessary to perform the TPS adaptation procedure with Scan tool when the throttle body assembly or ECM is replaced.

Erase previous TPS adaptation value using Scan tool.
Ignition "OFF" and then "ON" without cranking. Wait for 10 seconds under enable conditions
Enable conditions: Battery > 10V & Intake Air Temp. > 5.3°C (41.5°F) & 5.3°C (41.5°F)

Engine Coolant Temp. < 99.8°C (211.6°F)
After TPS adaptation, the system normality should be confirmed by reading out "FMY" on the Scan Tool