Control Circuit Inspection
- Check for short to ground in control circuit
- Measure voltage between terminal 2 of the CCV harness connector and chassis ground
Specification: Approx. 4-5V
- Is voltage within the specification?
YES : --> Go to next step
NO : --> Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure
- Measure voltage between terminal 2 of the CCV harness connector and chassis ground
- Check for short to power in control circuit
- Ignition "OFF"
- Disconnect ECM connector
- Ignition "ON" & Engine "OFF"
- Measure voltage between terminal 2 of the CCV harness connector and chassis ground
Specification: Approx. 0V
- Is voltage within the specification?
YES : --> Go to next procedure
NO : --> Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure