Network Gateway Ecu: Installation

WARNING: This page is about a different car, the 2006 Lexus IS 350 and 2006 Lexus IS 250. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL NETWORK GATEWAY ECU
1. Install the network gateway ECU.
  
  Fig 1: Identifying Network Gateway ECU
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Engage the 2 claws to install the cover.
3. Connect the connector.
INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY (See INSTALLATION )
INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY (See INSTALLATION )
INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (See INSTALLATION )
INSTALL SIDE INSTRUMENT PANEL (See INSTALLATION )
INSTALL FRONT DOOR OPENING TRIM COVER
INSTALL FRONT DOOR SCUFF PLATE
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
NOTE: Some systems need initialization when disconnecting the cable from the negative battery terminal (See INITIALIZATION ).
INSPECT SRS WARNING LIGHT
(see DIAGNOSIS SYSTEM )

Fig 2: Identifying Cover And Engaging Claws
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002