Optima & Magentis (Canadian)
NOTE:
DO NOT use OBD-II Data Link Connector (OBD-II DLC) for lab scope power source as this will affect waveform.
Set lab scope time to 20 milliseconds and voltage to 5 volts. Start engine and allow it to reach normal operating temperature. With engine at idle, compare CMP sensor waveform to normal CMP sensor waveform. See Fig 1. Connect lab scope as follows:
- On 2.4L (A/T) connect lab scope positive probe to ECM connector B01 terminal No. B16 (Black wire). See Figure. Connect lab scope negative probe to ground.
- On 2.4L (M/T) connect lab scope positive probe to ECM connector B01 terminal No. D18 (Black wire).See Figure. Connect lab scope negative probe to ground.
- On 2.5L, connect lab scope positive probe to ECM connector B01 terminal No. F7 (Black wire). See Figure. Connect lab scope negative probe to ECM connector B01 terminal No. F8 (Black/White wire).
If waveform is erratic, replace CMP sensor.