LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2024 >> Compass Latitude >> Repair and Diagnosis (Single Page) >> Quick Lookups >> Common Specs & Procedures >> Common Specs & Procedures
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Common Specs & Procedures

COMPASS COMMON SPECS & PROCEDURES

System Specification/Procedure
Air Conditioning
  Service A/C REFRIGERANT SYSTEM
  Torque TORQUE SPECIFICATIONS
Axle Nut/Hub Nut
  Front TORQUE SPECIFICATIONS
  Rear TORQUE SPECIFICATIONS
Battery BATTERY
Brakes
  Bleeding Sequence STANDARD PROCEDURE - BRAKE BLEEDING
  Service Specifications TECHNICAL SPECIFICATIONS
  Torque TORQUE SPECIFICATIONS
Charging
  Generator TECHNICAL SPECIFICATIONS
  Torque TORQUE SPECIFICATIONS
Drive Belts
  Adjustment Serpentine belt used, not adjustable.
  Drive Belt Routing Refer to appropriate figure under REMOVAL AND INSTALLATION
Engine Cooling
  General Service Specifications CAPACITIES AND RECOMMENDED FLUIDS
  Radiator Cap Pressure 21 psi
  Thermostat R & I THERMOSTAT
  Water Pump R & I PUMP, COOLANT
Engine Mechanical
  Compression CYLINDER COMPRESSION TEST
  Oil pressure See oil pressure table under ENGINE SPECIFICATIONS
  Overhaul ENGINE SPECIFICATIONS
  Torque TORQUE SPECIFICATIONS
Fluid Specifications See FLUIDS under MAINTENANCE/FLUIDS tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button.
Flywheel/Flex Plate/Drive Plate Torque 81 ft. lbs. (110 N.m)
Do not reuse these fasteners. If removed, a NEW  fastener must be installed and tightened to specifications.
Fuel System
  Pressure Specification 58 psi ± 3 psi (407 kPa ±34 kPa)
  Fuel Pressure Test Procedure CHECKING THE FUEL DELIVERY SYSTEM (HARD START)
  Fuel Filter Location Fuel filter is part of fuel pump module.
  Fuel Filter R & I ASSEMBLY, FUEL PUMP
Ignition
  Firing Order & Cylinder Identification FIRING ORDER & CYLINDER IDENTIFICATION
  Ignition Wires (Resistance) Coil On Plug
  Ignition Wires (Routing) Coil On Plug
Spark Plug
  Type Recommended to use MOPAR Spark Plugs.
  Gap 0.024 - 0.025 in. (0.60 - 0.65 mm)
  Torque 14 ft. lbs. (19 N.m)
Starting
  Torque TORQUE SPECIFICATIONS
Wheel Alignment
  Adjustment Specifications TECHNICAL SPECIFICATIONS
  Torque Front: TORQUE SPECIFICATIONS
Rear: TORQUE SPECIFICATIONS
Wheel & Tire
  Wheel Lug Nut Torque TORQUE SPECIFICATIONS