TBM2 Module

REMOVAL 

1. Remove the glove box assembly. Refer to GLOVE BOX, INSTRUMENT PANEL, LOWER, REMOVAL AND INSTALLATION .
2. Remove the right instrument panel trim panel. Refer to PANEL, INSTRUMENT PANEL TRIM, REMOVAL AND INSTALLATION .

   Courtesy of CHRYSLER GROUP, LLC

   1 - TBM2

   2 - Fastener

   3 - Antenna and Wire Harness Connectors

   4 - Instrument Panel

3. Through the instrument panel openings, disconnect the wire harness connectors and antennas from the Global Telematics Box Module (TBM2).
4. Remove the fastener from the TBM2.

   Courtesy of CHRYSLER GROUP, LLC

   1 - Instrument Panel

   2 - TBM2

   3 - Retaining Tabs

5. Slide to release the TBM2 from the retaining tabs and remove the TBM2 through the instrument panel opening.

INSTALLATION 

Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.

• Tighten fastener securely.