Display Screen Module

REMOVAL 

1. Disconnect and isolate the negative battery cable(s). Refer to BATTERY DISCONNECT AND CONNECT - STANDARD SINGLE BATTERY SYSTEM or BATTERY DISCONNECT AND CONNECT - ETORQUE SYSTEM .
   NOTE:

   It is not necessary to completely remove the floor console from vehicle.

2. Position the floor console rearward. Refer to CONSOLE, FLOOR, REMOVAL AND INSTALLATION .

   Courtesy of CHRYSLER GROUP, LLC

   1 - Display Screen Module

   2 - Fasteners

   3 - Floor Console

3. Working in the space in front of the floor console, remove the fasteners from the lower side of the instrument panel center bezel.

   Courtesy of CHRYSLER GROUP, LLC

   1 - Display Screen Module

4. Using a trim stick or equivalent, release the display screen module from the instrument panel.
5. Disconnect the wire harness connectors and remove the display screen module and bezel from the vehicle.

   Courtesy of CHRYSLER GROUP, LLC

   1 - Fasteners

   2 - Display Screen Module (DSM)

   3 - Bezel

6. If necessary, remove the fasteners that retain the DSM to the center bezel.

   Courtesy of CHRYSLER GROUP, LLC

   1 - DSM

   2 - Bezel

7. Separate the DSM form the center bezel.

INSTALLATION 

Follow the removal procedure in reverse for general reassembly of the components on the vehicle.