Integrated Trailer Control Module

REMOVAL 

1. Disconnect and isolate the negative battery cable(s). Refer to BATTERY DISCONNECT AND CONNECT - STANDARD SINGLE BATTERY SYSTEM or BATTERY DISCONNECT AND CONNECT - ETORQUE SYSTEM .
2. Remove the right D-pillar trim. Refer to PANEL, D-PILLAR TRIM, REMOVAL AND INSTALLATION .

   Courtesy of CHRYSLER GROUP, LLC

   1 - ITCM

   2 - Wire Harness Connector

3. Disconnect the wire harness connector from the Integrated Trailer Control Module (ITCM).

   Courtesy of CHRYSLER GROUP, LLC

   1 - Fastener

   2 - ITCM

4. Remove the fasteners and remove the ITCM from the vehicle.

INSTALLATION 

Follow the removal procedure in reverse for general reassembly of the components on the vehicle.