September 30: LEMON manuals is back up on a temporary server! Slowness is possible
Torque Specifications
| DESCRIPTION |
N. m |
Ft. Lbs. |
In. Lbs. |
COMMENT |
| Rear Drive Unit (RDU) Rear Mounting Bolt |
120 |
89 |
- |
- |
| Differential to RDU Bracket |
55 |
41 |
- |
- |
| Rear Propeller Shaft Bolts |
20 |
15 |
- |
Do not reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications. |
| Pump Bolts |
12 |
- |
106 |
- |
| Pressure Sensor |
21 |
15 |
- |
- |
| Bearing Plate to Intermediate Bracket Bolts |
24 |
17 |
- |
|
| Rear Driveshaft Bolts |
20 |
15 |
- |
Do not reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications. |
| Intermediate Bracket to Engine Block and Oil Pan Bolts |
65 |
48 |
- |
- |
| Eac Bracket to Engine |
55 |
41 |
- |
- |
| Heat Shield to PTU |
11 |
- |
97 |
- |
| Front Differential Bracket to Differential |
60 |
44 |
- |
- |
| Propshaft Center Bearing to Body |
10 |
- |
88 |
- |
| Front Halfshaft to Bearing |
200 |
148 |
- |
Do not reuse these fasteners. If removed, a NEW
fastener must be installed and tightened to specifications. |
| Rear Halfshaft to Bearing |
175 |
129 |
- |
Do not reuse these fasteners. If removed, a NEW
fastener must be installed and tightened to specifications. |
| PTU to Transaxle |
44 |
32.5 |
- |
- |
| Mounting Bracket to Engine Block |
44 |
32.5 |
- |
- |
| Front Differential Bracket to Isolator |
100 |
74 |
- |
- |
| Final Drive Gear to Differential |
163 |
120 |
|
- |
| Front Bearing to Knuckle |
113 |
83 |
|
- |
| Rear Bearing to Knuckle |
55 Plus 80° |
41 Plus 80° |
- |
- |
| Differential Fill Plug |
35 |
26 |
- |
- |
| RDU Hydraulic Fluid Cover Bolts |
6 |
- |
53 |
- |
1-SPEED RDM SPECIFICATIONS
| DESCRIPTION |
SPECIFICATION |
| GEAR RATIO |
2.73:1 |
| RING GEAR DIAMETER |
165 mm (6.5 in.) |
| DIFFERENTIAL FLUID FILL CAPACITY |
0.89 Liters |
| HYDRAULIC FLUID FILL CAPACITY |
0.439 Liters |