Module, Digital Audio Broadcasting Antenna: Removal
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Remove the driver side upper quarter trim panel. Refer to PANEL, QUARTER TRIM, REMOVAL
.
- Disconnect the digital audio broadcast antenna cable (1) from the digital audio broadcast antenna module (2).
- Disconnect the two wire harness connector (1) from the digital audio broadcast antenna module (2).
- Remove the fastener (1) and then remove the digital audio broadcast antenna module (2) from the C-pillar.