Front Toe
WARNING: This page is about a different car, the 2020 Chrysler 300 and 2019 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Perform the following procedure to each side of the vehicle as necessary.
CAUTION:
Do not twist the inner tie rod-to-steering gear boots during front wheel Toe adjustment. Remove the boot clamps (2) at the inner tie rods and make sure the boots move freely on the inner tie rods.
- AWD - Loosen the jam nut (1) at the inner-to-outer tie rod (3-4) connection.
- RWD - Loosen the jam nut (3) at the inner-to-outer tie rod (4-5) connection.
- Grasp the inner tie rod at the hex and rotate as necessary to adjust front toe to the preferred toe specification Refer to WHEEL ALIGNMENT, TECHNICAL SPECIFICATIONS .
- AWD - Tighten the tie rod jam nut (3) to 75 N.m (55 ft. lbs.) using care not to lose adjustment.
- RWD - Tighten the tie rod jam nut (3) to 75 N.m (55 ft. lbs.) using care not to lose adjustment.
- Make sure the inner tie rod-to-steering gear boot is not twisted, then reinstall the boot clamp at the inner tie rod.
- Adjust front toe on opposite side of vehicle using the above procedure as necessary.