LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2019 >> Wrangler Unlimited Moab >> Repair and Diagnosis >> Electrical >> Starter >> Starting System (Service Information) >> Relay, Power Control >> Removal And Installation >> Installation
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Removal And Installation: Installation

  1. Position the Power Control Relay (PCR) for installation.
  2. Install the PCR to ground mount nuts and tighten to the proper specification. Refer to TECHNICAL SPECIFICATIONS .
  3. Install the nuts on the B+ posts of the PCR and tighten to the proper specification. Refer to TECHNICAL SPECIFICATIONS .
  4. Connect the PCR wire harness connector.
  5. Install the right inner wheel house. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, REMOVAL AND INSTALLATION and SHIELD, SPLASH, REAR WHEELHOUSE, REMOVAL AND INSTALLATION .
  6. Remove the support and lower the vehicle.
  7. Connect the negative battery cable(s). Refer to STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals