LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2019 >> Renegade Trailhawk >> Repair and Diagnosis >> External Pages >> Different car >> Section 1352 (Speed Control (Service Information)) >> Switch, Speed Control >> Removal And Installation >> Removal
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Removal And Installation: Removal

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the Driver Air Bag (DAB). Refer to AIR BAG, DRIVER, REMOVAL .
  2. Remove the remote radio switches. Refer to SWITCH, REMOTE RADIO, REMOVAL .
    GC0169087Courtesy of CHRYSLER GROUP, LLC
  3. Remove the fastener (1a) and pull the speed control switch (1b) away from the steering wheel.
  4. Release the wire harness (2a) from the retainer and the wire harness connector (2b) from its retainer.
    NOTE:

    Note the routing of the wire harness in the steering wheel for ease of installation.

    GC0169193Courtesy of CHRYSLER GROUP, LLC
  5. Disconnect the wire harness connector (1).
  6. Remove the speed control switch (2).
NOTE:

Perform the same operation to remove the left remote radio switch and Electronic Vehicle Information Center (EVIC) switch on the opposite side of the steering wheel.

scientia non olet · About LEMON Manuals