Sensor, Crankshaft Position: Removal: 6.2L

Courtesy of CHRYSLER GROUP, LLC

The Crankshaft Position (CKP) sensor is located at the right-rear side of the engine block (1). It is positioned and bolted into a machined hole in the engine block.

1. Disconnect and isolate the negative battery cable.
2. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
3. Remove the starter. Refer to STARTER, REMOVAL .
4. Disconnect the CKP sensor wire harness connector (1).

   Courtesy of CHRYSLER GROUP, LLC

5. Remove bolt (1) and the CKP sensor from the engine block.