Removal And Installation: Installation

WARNING: This page is about a different car, the 2015 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Propeller shaft installation is a two-person operation. Never allow propeller shaft to hang from the center bearing, or while only connected to the transmission or rear axle flanges. A helper is required. If a propeller shaft section is hung unsupported, damage may occur to the shaft, coupler, and/or center bearing from over-angulation. This may result in driveline vibrations and/or component failure.

If removed, install the Rear Driveline Unit (RDM) actuator and tighten the screws.

Fig 1: RDU & Isolator Through Bolts
Courtesy of CHRYSLER GROUP, LLC
Raise the RDU (1a) into position and tighten the through bolts (1b) to the proper specification. Refer to SPECIFICATIONS .

Fig 2: Front RDU Mounting Bolt
Courtesy of CHRYSLER GROUP, LLC
Install the front RDU mounting bolt (1) and tighten to the proper specification. Refer to SPECIFICATIONS .
Remove the hydraulic lift.

Fig 3: Dust Seal
Courtesy of CHRYSLER GROUP, LLC
Install a new dust seal (1) on the pinion shaft of the RDU.

Fig 4: Snap Ring
Courtesy of CHRYSLER GROUP, LLC
Install a new snap ring (1) in the drive shaft.

Fig 5: Propeller Shaft & Pinion
Courtesy of CHRYSLER GROUP, LLC
Connect the propeller shaft to the pinion of the RDU, verify the snap ring is seated in the groove on the pinion shaft.

Fig 6: Dust Cover
Courtesy of CHRYSLER GROUP, LLC
Position the new dust cover over the joint at the rear of the propeller shaft.

Fig 7: Propeller Shaft Center Support Bolts
Courtesy of CHRYSLER GROUP, LLC
Install the propeller shaft center support bolts and tighten to the proper specification. Refer to SPECIFICATIONS .
Remove the propeller shaft support tools.
Remove the tape and the protective sleeve from the propeller shaft.
Connect the differential actuator wire harness connector.

Fig 8: RDU Code Location
Courtesy of CHRYSLER GROUP, LLC

NOTE:
If replacing the RDU, it is necessary to record the last two characters of the code in the area indicated (a) of the new RDU for performing the self learning procedure.
When replacing the RDU connect the diagnostic scan tool, enter Miscellaneous Functions of the DriveTrain Control Module (DTCM) and run the self-learning procedure for the RDU.
Check and correct the fluid level in the RDU. Refer to FLUID, DIFFERENTIAL, STANDARD PROCEDURE .
Install the rear stabilizer bar. Refer to STABILIZER BAR, REAR SUSPENSION, REMOVAL AND INSTALLATION .
Install the rear halfshafts. Refer to REMOVAL AND INSTALLATION .
Install the rear knuckles. Refer to KNUCKLE, REAR, REMOVAL AND INSTALLATION .
Install the rear tires and wheels. Refer to REMOVAL AND INSTALLATION .
Install the muffler. Refer to MUFFLER, EXHAUST, REMOVAL AND INSTALLATION .