Sensor, Particulate Matter: Installation: Installation

WARNING: This page is about a different car, the 2015 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Remove/Install Soot Sensor & NOx Sensor (1/2)

Courtesy of CHRYSLER GROUP, LLC

Install the Particulate Matter (PM) sensor (1) and tighten to 60 N.m (44 ft. lbs.).

Fig 2: Remove/Install Soot Sensor Wire Harness Connector
Courtesy of CHRYSLER GROUP, LLC
Install the PM module (4). Tighten the nuts (2) to 11 N.m (8 ft. lbs.).
Connect the PM sensor wire harness connector (1).

Fig 3: Remove/Install Module Mounting Bracket
Courtesy of CHRYSLER GROUP, LLC
Install the module mounting bracket (2). Tighten the nuts (1) to 11 N.m (8 ft. lbs.).

Fig 4: Heat Shield & Fasteners
Courtesy of CHRYSLER GROUP, LLC
Install the heat shield (2) and fasteners (1).

Fig 5: Fuel Filter Shield & Nuts
Courtesy of CHRYSLER GROUP, LLC
Install the fuel filter shield (1). Tighten the nuts (2) 14 N.m (10 ft. lbs.).
Remove the support and lower the vehicle.
Connect the negative battery cables.