LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2015 >> Compass Limited, AWD, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Battery System) >> TRAY, Battery >> Removal >> Removal
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

TRAY, Battery: Removal: Removal

WARNING: This page is about a different car, the 2009 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Electrical Connector, Battery, Battery Tray & Solenoid
GC0085941Courtesy of CHRYSLER LLC
NOTE: Left hand drive gasoline engine shown, right hand drive and diesel similar.
  1. Disconnect and isolate the battery negative cable.
  2. Remove the battery. See Electrical - Engine Systems/Battery System/BATTERY - Removal .
  3. On gasoline engine equipped vehicles, disconnect the purge solenoid vacuum hose and electrical connector (1). Using an appropriate flat bladed tool, remove the solenoid (4) from the battery tray (3) by disengaging the solenoid mounting clip and lifting it up off the battery tray mounting tab.
    Fig 2: Identifying TIPM Positive Cable Retaining Nut, Cable, Mounting Stud & Totally Integrated Power Module (TIPM) Cover
    GC0085937Courtesy of CHRYSLER LLC
  4. Open the Totally Integrated Power Module (TIPM) cover (4).
  5. Remove the TIPM positive cable retaining nut (1) and remove the cable (2) from the mounting stud (3).
    Fig 3: Identifying Integrated Power Module (TIPM), TIPM Mounting Bracket & Mounting Tabs
    GC0085942Courtesy of CHRYSLER LLC
  6. Using an appropriate flat bladed tool, depress the four mounting clips to disengage and remove the TIPM housing (1) from the TIPM bracket mounting tabs (3).
    Fig 4: TIPM Housing
    GC0100789Courtesy of CHRYSLER LLC
  7. Disconnect each of the seven TIPM wire harness connectors from the TIPM housing (2).
  8. Remove the TIPM from the vehicle.
    Fig 5: TIPM Bracket Retaining Screws, Bracket, Mounting Tabs & Battery Tray
    GC0085943Courtesy of CHRYSLER LLC
  9. Remove the TIPM bracket retaining screws (1) and slide the bracket (2) rearward to disengage the mounting tabs (3). Remove the TIPM bracket from the battery tray (4).
    Fig 6: Nuts, Plastic Battery Tray & Inner Fender
    GC0085940Courtesy of CHRYSLER LLC
  10. Remove the three nuts (1) securing the battery tray (2) to the left inner fender (3).
  11. Lift the battery tray out of the engine compartment and remove from the vehicle.
scientia non olet · About LEMON Manuals