LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2014 >> Grand Cherokee Laredo, AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Electronic Control Modules (Service Information) >> Module, Ignition Node >> Removal >> Removal
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Module, Ignition Node: Removal: Removal

Fig 1: Removing/Installing Switch Mounting Screws
GC0121041Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect the and isolate the negative battery cable.
  2. Remove the dash end cap (Refer to REMOVAL ).
  3. Remove the steering column opening cover.
  4. Remove the chin bezel located above the floor console. One fastener snaps to the console. Refer to CONSOLE, FLOOR, REMOVAL .
  5. Disconnect the wire harness connector from the Ignition Node Module (IGNM).
  6. Remove 4 screws that retain the IGNM in place.
  7. Disconnect the wiring harness connector from the back of the IGNM.
  8. Remove the IGNM from the backside of the instrument panel.
scientia non olet · About LEMON Manuals