LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2012 >> Wrangler V6-3.6L >> Repair and Diagnosis >> Heating and Air Conditioning >> Cabin Temperature Sensor / Switch >> Service and Repair >> In-Car Temperature Sensor - Removal
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

In-Car Temperature Sensor - Removal





REMOVAL

WARNING: Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.

NOTE: LHD model shown. RHD model similar.





1. Disconnect and isolate the negative battery cable.
2. Remove the steering column opening cover Steering Column Opening Cover - Removal.
3. Disconnect the wire harness connector (1) from the in-car temperature sensor (2).
4. Remove the two screws (3 and 4) that secure the in-car temperature sensor to the instrument panel (5) and remove the sensor.

scientia non olet · About LEMON Manuals