Adaptive Cruise Control Verification Test

WARNING: This page is about a different car, the 2015 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect all jumper wires and reconnect all previously disconnected components and connectors.
With the scan tool, erase Adaptive Cruise Control (ACC) DTCs.
Make sure that all accessories are turned off and that the battery is fully charged.
If the ACC Module was replaced or moved in any way, the ACC Module must be aligned. Perform both the Vertical and Horizontal Sensor Alignment procedures in accordance with the Service Information. Refer to MODULE, ADAPTIVE CRUISE CONTROL, MODULE PROGRAMMING .
Test drive the vehicle and verify proper operation.
With the scan tool, read ACC Module DTCs and record on the repair order.
Are there any DTCs present in the ACC Module?

Yes
- Repair the ACC Module DTC(s). Refer to DIAGNOSIS AND TESTING .
No
- Repair is complete.