Sensor, Accelerator Pedal Position: Removal: Removal
WARNING: This page is about a different car, the 2012 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Courtesy of CHRYSLER GROUP, LLC
| 1 - HARNESS CONNECTOR |
| 2 - FASTENERS |
| 3 - ACCELERATOR PEDAL ASSEMBLY |
- Disconnect the negative battery cable.
- Remove the drivers side lower dash board close out panel.
- Disconnect the APPS wire harness connector (1).
- Remove the nuts (2) and the accelerator pedal assembly (3).