Section 750 (Driveshaft): Removal: Front
WARNING: This page is about a different car, the 2020 Chrysler 300 and 2019 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE
.
- Remove driveshaft heat shield (1).
- Apply alignment index marks on the driveshaft and front and rear flanges.
- Remove and discard the four front driveshaft to axle flange bolts (2).
- Remove and discard four front driveshaft to transfer case flange bolts (2).
- Remove propeller shaft assembly (1).