LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2012 >> Compass Limited, AWD, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 652 (Power Transfer Unit (Service Information) - MK) >> Installation
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Section 652 (Power Transfer Unit (Service Information) - MK): Installation

WARNING: This page is about a different car, the 2017 Jeep Patriot and 2017 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.
GC0158262Courtesy of CHRYSLER GROUP, LLC
  1. Roll the PTU (1) rearward and up to install.
  2. Place the PTU in position on the transaxle.
    GC0084385Courtesy of CHRYSLER GROUP, LLC
  3. Lower the front of the engine until the rear mount has aligned (1 and 2).
    GC0084384Courtesy of CHRYSLER GROUP, LLC
  4. Remove a screw jack (2) from under the engine mount bracket (1)
    GC0158263Courtesy of CHRYSLER GROUP, LLC
  5. Install the bolts (1) to hold the lower PTU to the transaxle. Refer to TECHNICAL SPECIFICATIONS .
    GC0158291Courtesy of CHRYSLER GROUP, LLC
  6. Install the bolts (1) to hold the upper PTU to the transaxle. Refer to TECHNICAL SPECIFICATIONS .
    GC0158274Courtesy of CHRYSLER GROUP, LLC
  7. Place the front-to-rear support in position on the vehicle.
  8. Install the bolts (2) to hold the front-to-rear support to the front and rear crossmembers. Refer to TECHNICAL SPECIFICATIONS .
  9. Install the trough bolt (1) to hold the front-to-rear support rubber isolator to the front crossmember. Refer to TECHNICAL SPECIFICATIONS .
    GC0158298Courtesy of CHRYSLER GROUP, LLC
  10. Install the hidden trough bolt (1) to hold the engine mount to the engine cradle above the PTU (2). Refer to TECHNICAL SPECIFICATIONS .
  11. Lower the vehicle.
    GC0084381Courtesy of CHRYSLER GROUP, LLC
  12. Remove the bungie cord and slide the maniverter down and to the left into position on the engine.
  13. Install the exhaust maniverter. Refer to MANIFOLD, EXHAUST, INSTALLATION .
  14. Raise the vehicle.
    GC0084378Courtesy of CHRYSLER GROUP, LLC
  15. Install the bolts (1) to hold the exhaust pipe to the maniverter. Refer to TECHNICAL SPECIFICATIONS .
  16. Install the rear prop shaft. Refer to INSTALLATION .
  17. Install right front halfshaft. Refer to INSTALLATION .
    GC0158268Courtesy of CHRYSLER GROUP, LLC
  18. Remove the fill plug (2) and add fluid to the proper level. Refer to STANDARD PROCEDURE - DRAIN AND FILL  .
  19. Lower the vehicle.
  20. Install the air cleaner. For 2.4L, refer to BODY, AIR CLEANER, INSTALLATION . For 2.0L, refer to BODY, AIR CLEANER, INSTALLATION
  21. Install the engine cover.
  22. Connect the battery negative cable. Refer to CABLES, BATTERY, REMOVAL .
  23. Road test the vehicle to verify the repair.
scientia non olet · About LEMON Manuals