Standard Procedure - Memory System Programming

WARNING: This page is about a different car, the 2012 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

The Memory Seat Module (MSM) interfaces with the Remote Keyless Entry (RKE) system via the Controller Area Network (CAN) bus. The proper procedure of setting and recalling a memory position using the RKE is as follows:

Press and release memory switch 1 or 2 to recall memory position 1 or 2.
Adjust the seat, recliner, adjustable pedal position, set radio station presets, set HVAC temperature preset, and the side view mirrors to the desired position.
Press momentarily and release memory switch S.
Within five seconds, press momentarily and release memory switch 1 or 2.
To link the RKE transmitter: within ten seconds, press and release the "LOCK" button on one of the RKE transmitters

To program the second driver's position, repeat the above procedure using memory switch 2. The second RKE transmitter can be programmed in the same fashion as indicated. Refer to 5.

NOTE:

The module will abort a recall if the transmission is moved out of park or if any seat movement is activated whether manually or by memory recall. The module will also abort a recall if any movement of the adjustable pedals is detected.

To recall either of the programmed positions momentarily press and release either memory selector switch 1 or 2. If using RKE, just press and release the "UNLOCK" button on the proper transmitter for either position 1 or 2.

A recall is possible any time the vehicle transmission is in PARK and the seatbelt is unbuckled. This condition is monitored by the MSM.