LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2008 >> Liberty Limited, RWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Vehicle Theft Security System (Service Information) >> Vehicle Theft Security - Service Information >> Intrusion Module >> Removal >> Intrusion Module
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Intrusion Module

Fig 1: Identifying Intrusion Module , Left Inner D-Pillar, Plastic Push-In Fasteners & Body Wire Harness
GC0061950Courtesy of CHRYSLER LLC
  1. Disconnect and isolate the battery negative cable.
  2. Partially remove the trim from the inside of the left inner D-pillar (3). Refer to REMOVAL .
  3. Disconnect the take out of the body wire harness (2) from the connector receptacle on the forward-facing side of the intrusion module (1).
  4. Remove the two plastic push-in fasteners (4) that secure the module to the inner D-pillar.
  5. Remove the module from the inner D-pillar.
scientia non olet · About LEMON Manuals