Removal

REMOVAL

WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.





1. Disconnect and isolate the battery negative cable. Wait two minutes for the system capacitor to discharge before further service.
2. Reach under the front seat cushion to access the seat track position sensor (3) in a bracket (5) located on the inboard side of either the inner or outer, driver or passenger seat track.
3. Disconnect the seat wire harness connector (4) from the sensor.
4. Remove the screw (1) that secures the sensor mounting boss to the bracket.
5. Using a small screwdriver, depress the sensor latch feature (2) and pull the sensor out of the bracket.