LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2006 >> Commander Base, 3.7 K, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (HVAC Systems (Service Information)) >> Controls >> Transducer-A/C Pressure >> Installation
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Transducer-A/C Pressure: Installation

WARNING: This page is about a different car, the 2006 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Use only the specified O-ring as it is made of special material for R-134a. Use only refrigerant oil of the type required for the A/C compressor.
Fig 1: Removing/Installing A/C Pressure Transducer
GC0007399Courtesy of DAIMLERCHRYSLER CORP.
  1. Lubricate a new rubber O-ring seal (4) with clean refrigerant oil and install it onto the discharge line fitting (3).
  2. Install the A/C pressure transducer (2) onto the A/C discharge line. Tighten the A/C pressure transducer securely.
  3. Connect the wire harness connector (1) to the A/C pressure transducer.
  4. Reconnect the negative battery cable.
scientia non olet · About LEMON Manuals