Section 25 (HVAC Systems (Service Information)): Controls: Control-A/C-Heater: Installation
WARNING: This page is about a different car, the 2006 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Position the A/C-heater control (4) and the electronic vehicle information center (EVIC) control (3) into the instrument panel center bezel (1).
- Install the screws (2) that secure the A/C-heater control and the EVIC control to the center bezel. Tighten the screws to 2 N.m (17 in. lbs.).
- Install the center bezel onto the instrument panel (Refer to BODY/INSTRUMENT PANEL/INSTRUMENT PANEL CENTER BEZEL - INSTALLATION) .
- Reconnect the negative battery cable.
- Initiate the Actuator Calibration function using a scan tool. Refer to HVAC System Test, found in DTCS U0159 TO U0241, BLOWER MOTOR TESTS, HVAC SYSTEM TESTS & A/C HEATER CONTROL DIAGNOSIS .