LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2006 >> Commander Base, 3.7 K, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 122 (Vehicle Theft Security System (Service Information)) >> Intrusion Sensor >> Removal >> Intrusion Sensor Receiver
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Intrusion Sensor Receiver

WARNING: This page is about a different car, the 2007 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Intrusion Sensor Receiver
GC0040906Courtesy of CHRYSLER LLC
  1. Disconnect and isolate the battery negative cable.
  2. Remove the overhead console from the headliner. Refer to REMOVAL .
  3. Locate the intrusion sensor receiver (1) in the mounting bracket (4) on the right front corner of the overhead console housing (3).
  4. Disconnect the take out of the overhead wire harness from the connector receptacle (5) on the rearward end of the receiver housing.
  5. Release the three latch features (2) of the mounting bracket and disengage the receiver from the bracket.
scientia non olet · About LEMON Manuals