Sensor-Crankshaft Position: Installation
WARNING: This page is about a different car, the 2006 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Courtesy of DAIMLERCHRYSLER CORP.
| 1 - HEAT SHIELD |
| 2 - CRANKSHAFT POSITION SENSOR |
- Clean the crankshaft sensor bore and install the sensor (2). See Fig 1. Tighten the bolt to 9 N.m (80 in. lbs.).
- Connect the engine harness connector.
- Install the heat shield (1). See Fig 1.
- Lower the vehicle.
- Connect the negative battery cable.