LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2006 >> Commander Base, 3.7 K, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 101 (3.7L Engine (Service Information)) >> Lubrication >> Sensor/Switch-Oil Pressure >> Installation
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Sensor/Switch-Oil Pressure: Installation

WARNING: This page is about a different car, the 2007 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Oil Pressure Sending Unit
GC0011823Courtesy of CHRYSLER LLC
  1. Install the oil pressure switch.
  2. Connect oil pressure switch connector.
  3. Install front splash shield.
  4. Lower vehicle.
  5. Connect the negative battery cable.
  6. Start the engine and ensure there are no oil leaks from the oil pressure switch.
scientia non olet · About LEMON Manuals