LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2006 >> Commander Base, 3.7 K, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 101 (3.7L Engine (Service Information)) >> Cylinder Head >> Arm-Rocker >> Installation
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Cylinder Head: Arm-Rocker: Installation

WARNING: This page is about a different car, the 2007 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using the Remover/Installer 8516 (2) press downward on the valve spring and install the rocker arm.
    Fig 1: Installing Rocker Arm
    GC0011768Courtesy of CHRYSLER LLC
    CAUTION: Make sure the rocker arms are installed with the concave pocket over the lash adjusters. Failure to do so may cause severe damage to the rocker arms and/or lash adjusters.
    NOTE: Coat the rocker arms with clean engine oil prior to installation.
  2. For rocker arm installation on cylinders No. 4, Rotate the crankshaft until cylinder No. 1 is at BDC intake stroke.
  3. For rocker arm installation on cylinder No. 1, Rotate the crankshaft until cylinder No. 1 is at BDC combustion stroke.
  4. For rocker arm installation on cylinders No. 3 and No. 5, Rotate the crankshaft until cylinder No. 1 is at TDC exhaust stroke.
  5. For rocker arm installation on cylinders No. 2 and No. 6, Rotate the crankshaft until cylinder No. 1 is at TDC ignition stroke.
  6. Install the cylinder head cover. See INSTALLATION .
scientia non olet · About LEMON Manuals